The (Part Number 006-00673-XXXX) is the definitive technical resource for avionics technicians installing or maintaining the KT 70 Mode S transponder. This manual covers everything from physical mounting to complex Mode S address programming. 🛠️ Installation Specifications
Use RG-58C/U or similar high-quality shielded coaxial cable to connect the antenna to the transponder. 5. Post-Installation Configuration and Testing Once installed, the system must be configured and tested.
Secure a continuous supply of cooling air to the rear of the unit. Connect a 1-inch cooling hose from the aircraft's forced air plenum to the cooling port on the mounting rack. Antenna Placement Kt 70 Installation Manual
: Ensure the antenna makes a clean, bare-metal connection to the aircraft skin to establish a proper ground plane. Use an internal doubler plate on fabric or composite airframes to simulate a conductive aluminum surface. Post-Installation Configuration & Checkout
Ensure you cross-reference your specific altitude encoder's manual with the KT 70 pinout diagram to avoid matching errors that cause the transponder to report intermittent or incorrect altitudes to ATC. 4. Antenna Installation and RF Requirements The (Part Number 006-00673-XXXX) is the definitive technical
The mechanical section of the manual details the positioning and physical securing of the mounting tray. Proper placement guarantees structural integrity and adequate thermal cooling.
: The altitude readouts on the KT 70’s display must be explicitly cross-checked against the primary cockpit altimeter to verify flawless parallel Gray code transmission. Modern Regulatory Notice: ADS-B Out Compliance Connect a 1-inch cooling hose from the aircraft's
Includes detailed dimensions for the mounting tray and location considerations, such as antenna placement relative to the engine and landing gear to ensure a clear ground plane. Electrical Wiring:
