: Operates at 1500 Watts for maximum heat output in larger or uninsulated rooms.
Slowly rotate the counter-clockwise until you hear a distinct "click" and the heating element shuts off.
| Problem | Likely Solution | | :--- | :--- | | | Check the wall outlet (test a lamp). Check the circuit breaker. Press the Manual Reset button on the back. | | Heater runs but blows cold air | Dial is on "Fan Only" (Position 1). Switch to High (Position 3). The safety thermal cut-off may be tripped (unplug/reset). | | Heater smells like burning | First time use: Normal (dust burning off). Run it on high for 10 minutes outdoors. Old heater: Unplug immediately. Clean dust out. If smell persists, discard the unit. | | Unit shuts off after 10 minutes | Overheating. Move it away from walls/obstructions. Clean the intake grille. | patton heater model poh2501 manual
Unlike small heaters, the POH2501 has a separate (marked "Fan" or "Vent").
Keep the unit in a cool, dry location away from moisture and extreme temperature fluctuations. Troubleshooting Guide Potential Cause Recommended Solution The unit is not plugged in securely. Check the connection at the wall outlet. The wall outlet or circuit breaker has tripped. Reset the home circuit breaker or try a different outlet. The thermostat is set lower than room temperature. Turn the thermostat knob clockwise to a higher setting. The tip-over switch is engaged. : Operates at 1500 Watts for maximum heat
Always turn off the heater, unplug it, and let it cool completely before cleaning.
Use a vacuum cleaner with a brush attachment to gently remove dust and lint from the front exhaust grill and rear intake vents. Check the circuit breaker
Position the heater so it faces the area you wish to heat, keeping the 3-foot clearance rule in mind. Selecting the Mode
Circulates ambient room air without activating the heating elements.