Mai 2026
9
Press * (The indicator light returns to normal). Changing the Master Code Enter Programming Mode.
Typically housed in a robust, weather-resistant plastic casing.
A: The access mode is determined by how you add the user. Using key 0 adds a user that requires both a card and a PIN (Card + PIN). Using key 2 adds a user that requires either a card or a PIN (Card or PIN).
In programming mode, press 1 + Slot ID + # + 4-Digit PIN + # . V2000-c Rfid Access Control User Manual
If you encounter issues with the V2000-C RFID access control system, refer to the troubleshooting guide below:
It is designed for single-door control (electric lock, exit button, alarm, door sensor).
The system is now reset to factory defaults. The Master Code reverts to , and all system settings return to standard configuration. Note: User data (cards and PINs) will not be deleted during this hardware reset. Troubleshooting Press * (The indicator light returns to normal)
The V2000-C RFID access control system is a state-of-the-art access control solution that utilizes RFID (Radio Frequency Identification) technology to grant access to authorized individuals. The system consists of a control panel, RFID readers, and electronic locks. The control panel is the brain of the system, responsible for processing access requests, verifying user credentials, and controlling the locks.
Press * followed by your (Factory default is usually 123456 or 881122 ), then press # .
Press and hold the Reset button (or bridge the jumper pins). A: The access mode is determined by how you add the user
| Terminal | Label | Connection | Wire Gauge (AWG) | | :--- | :--- | :--- | :--- | | 1 | +12V | Power Supply Positive (10-14V DC) | 18-22 | | 2 | GND | Power Ground / Common Negative | 18-22 | | 3 | NO | Normally Open (Magnetic Lock) | 18 | | 4 | COM | Common (Lock Relay) | 18 | | 5 | NC | Normally Closed (Electric Strike - Fail Secure) | 18 | | 6 | PUSH | Exit Button Signal (Short to GND to activate) | 22 | | 7 | SEN | Door Contact Sensor (Magnetic Reed Switch) | 22 | | 8 | AL+ | Alarm Output (+) | 22 | | 9 | AL- | Alarm Output (-) | 22 | | 10 | +12V | Reader Power (For external reader – rarely used) | 22 | | 11 | DATA0 | Wiegand Data 0 (For external reader) | 22 | | 12 | DATA1 | Wiegand Data 1 (For external reader) | 22 |
Connect the wire of the V2000-C directly to the Positive (+) terminal of the Electric Strike. 3. Programming and Configuration Guide
Press 1 ➔ Enter a ➔ Press # ➔ Swipe the Card ➔ Press # . Add PIN User :