Updated - Xc2003 Controller Manual

: PACE provides additional flow at lower pressure settings and enhances overall fuel efficiency. Atlas Copco Operational Workflow According to the Xc2003 Big Book of Everything , the controller manages the entire machine lifecycle:

: Displays real-time operational diagnostics, warnings, diagnostic codes, and primary fluid levels.

The XC2003 appears as a virtual COM port. Download the CH340 or PL2303 driver (link in manual). After install, note the COM port number (e.g., COM3). xc2003 controller manual

Install the controller inside an IP54-rated electrical enclosure to protect internal circuits from dust, oil mist, and humidity.

The is an Atlas Copco controller designed for their "versatility range" of portable air compressors. It uses PACE technology (Pressure Adjusted through Cognitive Electronics) to allow a single compressor to operate at various pressure settings. Core Interface & Operations : PACE provides additional flow at lower pressure

ECO-mode is designed to reduce fuel consumption during periods of idling, such as when changing tools or during operator breaks. In traditional compressors, the engine continues to run and consume fuel even when no air is demanded. ECO-mode automatically shifts the compressor from an unloaded idle to a no-load state, causing the engine speed to drop and pressure to decrease gradually. This reduces fuel consumption by up to during idle periods, delivering significant cost savings over time. Furthermore, the system is designed to resume full operation instantly when an air demand is detected. Operators can also configure ECO-mode parameters, such as the minimum pressure and the delay before it activates, offering flexible control.

Alternatively, if you're looking for the I can help you refine your search to find the specific version for your machine. XC2003 Controller Overview and Fault Codes | PDF - Scribd Download the CH340 or PL2303 driver (link in manual)

Replacement interface sticker/keypad for controller (Part #1626850001 or 1626850006) ~$49 – $54

To connect the XC2003 to a PC for programming: