Manual: Dp Dual Trac 20 Assembly

DP Dual Trac 20 Assembly Manual: The Complete Step-by-Step Guide

Do you have the or are you working without visual aids? Is your machine missing any original parts or labels ?

The base provides the foundational stability for the entire machine. Lay the flat on the floor. Dp Dual Trac 20 Assembly Manual

Secure it at the bottom using two long hex bolts and washers.

Slide the foam rollers onto the leg developer shafts and secure them with the plastic end caps. Step 6: Cable and Pulley Routing (Critical Step) DP Dual Trac 20 Assembly Manual: The Complete

The heavy H-shaped or T-shaped steel stabilizer tubes that sit flat on the floor.

The assembly process can be divided into several stages: Lay the flat on the floor

Over time, brand-new steel cables will stretch slightly. If there is slack in the line when the weight stack pin is inserted:

Place a pulley wheel underneath the cable inside the bracket, insert a pulley bolt through the bracket and wheel, and secure it with a locknut.

Pay close attention to cable routing during assembly to prevent premature wear. 2. DP Dual Trac 20 Assembly Steps

Bolt the or rear crossmember to the back of the base frame using the designated carriage bolts, washers, and hex nuts.